$10 Shaboo Prints Windshield Repair Kits, Windshield Glass Repair To Automotive Tools Equipment Body Repair Tools Shaboo,To,Glass,/submit-your-photos/,www.saferlines.com,Windshield,Repair,$10,Kits,,Prints,Windshield,Repair,Automotive , Tools Equipment , Body Repair Tools Shaboo Prints Ranking TOP11 Windshield Repair Glass Kits To Shaboo Prints Ranking TOP11 Windshield Repair Glass Kits To $10 Shaboo Prints Windshield Repair Kits, Windshield Glass Repair To Automotive Tools Equipment Body Repair Tools Shaboo,To,Glass,/submit-your-photos/,www.saferlines.com,Windshield,Repair,$10,Kits,,Prints,Windshield,Repair,Automotive , Tools Equipment , Body Repair Tools
Why we need this windshield crack repair kit instead of go to the 4S store?
we may notice that some small chips or cracks in the windshield and sometimes they may even affect safety driving, it may be a bit troublesome or expensive to go to 4S store, thus here has the windshield repair kit to help you do it at home, saving your money and time.
In fact, because the front and back windshields are double-layered laminated glass, if the crack is not large, you can totally repair it by yourself.
Shaboo Prints Windshield Repair Kit makes permanent air-tight repairs on most smalll damaged laminated windshield glass, including bullseyes up to 1.25 inches, in just a few minutes you can get a new wind windshield.
Special design for all types of laminated windshields, this glass repair kit suitable for small chips, bulls-eye, star-shaped, Half-moon crescents, cracks that not more than 8 inches/ 20 cm, and round damage less than one inch in diameter(not for cellphone screen)
1. Clean the broken area.
2. Align the middle hole of the bracket to the damaged area.
3. Rotate the pressure cylinder onto the installed rigging.
4. Put 4-6 drops of repair solution into the pressure cylinder.
5. Rotate the lever to the pressure cylinder and wait patiently for 10-20 minutes to allow the repair fluid to slowly enter the broken hole.
6. Remove the repair device. Observe the penetration effect.
7. Apply a few drops of repair solution to the damaged area and cover with curing film.
8. Move the vehicle to the sunlight and let the sunlight fully shine for 20-30 minutes to solidify the repair solution (please drain the air bubbles before curing).
9. After curing, remove the curing film. Use razor body to gently scrape off the excess solids.
1. The windshield glass surfaces must be clean and dry.
2. Repair should be made in the shaded area.
3. Can not be use on pure scratches or small dots.
4. Do not allow the resin to come into contact with the car’s painted finish, wiper blades or plastic trim as this may cause damage.
5.Only suitable for the front and rear windshield.
6. Don't let the area be exposed to the sun while you are working on the fix until finished beause the resisn solidifies in the sun. Then let sit in the sun to curing the resin 15-20 mins.
7. Please make sure that the permeate was completed and then cured, because it can't repaired again after cured.